Coffee Latte Art Tutorial

Friends who like coffee latte art, I am glad that you like coffee like me and are willing to spend time learning about coffee. To be a professional barista, you must first learn how to make coffee. Coffee latte art is just one of the skills a barista has. Latte art skills require constant practice and correction of mistakes to gain something from failure. I can see a lot of fancy coffee latte art patterns on the Internet, and these patterns are also the dream of most friends who want to learn coffee.

Tulip Latte Art

1. After the fusion is completed, select a point in the center to increase the flow rate, and stop injecting after the pattern appears.

2. Based on the last selected point, inject a little later, increase the flow rate slightly, and stop injecting after the graph appears.

3. Repeat the second step to make the middle part of the tulip.

4. The last figure is the method of pulling the heart. When closing, raise it and slowly close it into a straight line.

Wheat ear production method

1. Create a tulip shape in the center of the cup. Remember not to make it too big and leave more space on the edges to make ears of wheat.

2. Choose a spot at the end of the tulip, inject the milk foam, and then perform the three steps (increasing the flow, swinging, and withdrawing) at the same time.

3. Reduce the flow rate at the end, the smaller the better.

How to make embossed leaves

1. After the fusion is completed, select a point at the center, inject and increase the flow to swing. When the pattern appears, don't be anxious, increase the flow at the original place and continue to swing.

2. When the first stripes are pressed up, swing the drawing cylinder while retreating and continue to increase the flow rate.

3. At the end, you also need to raise the latte art cylinder and reduce the flow rate to a small level.

The Dragon's Way

1. After the fusion is completed, select a point on the side of the cup, increase the flow rate and swing the latte art cylinder when you see the liquid start to rotate and flow.

2. Finally, move the embossing pitcher to pour out the outline of the faucet, and then use a piping pin to draw the shape of the dragon.

Melody Heart Method

1. After the fusion is completed, inject at a greater flow rate 0.5 cm close to the cup wall and shake.

2. After the rotation state is achieved, move the drawing cylinder to the center of the cup and increase the flow rate to swing the drawing center.

Embossed Tulip Method

1. After the fusion is completed, select a point at the center, inject and increase the flow to swing. When the pattern appears, don't be anxious, increase the flow at the original place and continue to swing.

2. Stop injecting when the first stripes are pressed up.

3. Based on the last selected point, inject a little later, increase the flow rate slightly, and stop injecting after the graph appears.

4. Repeat the second step to make the middle part of the tulip.

5. The last figure is the method of pulling the finger. When closing, raise it and slowly close it into a straight line.